[7 Great ways] How to Clean Bearpaw Boots effectively!

What can be better than wearing a perfect and comfy pair of Bearpaw boots during the winter season?  These boots are made of sheepskin lining, Suede,  and cow leather outer which protects your feet from cold and keeps your feet warm, as Bearpaw contains an organic insulator which helps in keeping the moisture away Evidently, Bearpaws are meant only for the cold weather. a brand that can be worn with jeans or corduroy pants, tucked in or with a bootcut to fit over the boot, and Bearpaw believes in making shoes that are good from the inside out.

Over the years Bearpaw boots has carved out a niche area by providing customers with comfort and sensibility to set itself apart. From slippers to boots to casual footwear, only the finest materials are used to produce Bearpaw boots and As you’ve made a major shoe investment, we know you want to keep your Bearpaw boots looking brand new.

Not the easiest of tasks but so long as you don’t drag them through sleet, snow or worse rain but somehow when this happens to yours Bearpaw then don’t worry!

In this article about How to clean Bearpaw boots,  however,  cleaning Bearpaw is a bit tricky so here will be discussing all the possible methods and procedures to make it look brand new again!

7 ways how to clean bearpaw boots

1.How to get rid of Water Stains?

Use Suede or Soft-bristled brush

• Always brush your Bearpaw boots with a suede, sponge or a soft brush to remove the dust and dirt from the upper layer of the boots from the toe area to the neck of the boot until it looks clean and tidy again if this is not enough then apply a detergent made specifically for cleaning leather on the stained area of your boots and be gentle!
• thoroughly clean the Bearpaw by rubbing clockwise on the stained area
• Wipe away any excess mud from the soles with a wet paper towel.
• Remember! not to over saturate or soak them in afterwards keep it outside to air dry
• Bearpaws boots must be dried by natural means in a well-ventilated location
• Don’t use a heater or blow dryer to dry your winter boots or place the boots under the direct heat of the sun. The upper material might fringe and you will not love the result.

Also Read

 Are Birkenstocks good for flat feet ? [FAQs Answered]

2. How should I remove tough Oil Stains

Use Talcum powder or Chalk

 

• Cover the oily stain with a decent layer of powder, cornstarch or chalk dust and let it remain on the stain for at least an entire day. Brush away the powder and repeat until the stain is gone.
• For the chalk, method rub it on the stain and a then leave it afterwards wipe or

Brush away the powder with an old toothbrush. You may need to repeat the procedure to get all of the oily stains off the suede.

3.How to Clean the inside wool of Bearpaw?

Use Baking soda or Antifungal spray

 

• Even though chlorine bleach is an excellent disinfectant, do not use it because it will cause the hide to stiffen and if too strong, the sheared wool will disintegrate.
• Use pine oil or phenolic disinfectant, such as Lysol mix a solution of the disinfecting cleaner and warm water and apply it on the inside of the boot though the best way to kill fungus in the boots is to use an anti-fungal spray.
• Now that your boots are cleaned inside and out, allow them to air-dry away from direct heat for at least 24 hours. Allowing them to dry slowly that means no clothes dryer or hot hair dryer will prevent cracking and damage to the hide.
• To remove a smelly odour from your boots take a teaspoon of baking soda and sprinkle it inside the boots leave it for 24 hours next day remove the baking soda and clean it completely with tissue

keep it outside for better results !

 

4. How to get rid of Scuff Marks?

Use an Eraser or a Towel

 

• Use any clear white coloured artist eraser or a or a clean white towel to gently buff away the scuff.
• Take care not to rub too hard and always follow the nap of the sheepskin follow the proper direction
• Always try to maintain a one-way process only changing the motion and movements of hands might ripple the area

Finish by brushing with a suede brush to lift the nap.

5. How to should I clean the Salt Stains?

Use Vinegar and Water

 

• Mix one tablespoon of distilled white vinegar and one cup of lukewarm water in a bowl. Dip the towel in the solution and gently wipe the salt-stained area.
• The acetic acid in the vinegar will gently dissolve the salt. Finish by dipping the towel or cotton wet the boots to plain water and wipe down all over until they are evenly wet.
• Do not soak the entire boot evenly to prevent watermarks. When the boots are dry, brush with the suede brush to lift the nap

Voila! now you just need to dry it. Either blow-dry it or put it outside a dry and clean place

 

Also Read

 Best work boots for bad knees & Buyer’s Guide [2021]

6.How to remove Chewing Gum or Ink Stains?

Use Rubbing Alcohol and Ice

• keep a tissue or paper towel soaked in a bowl of rubbing alcohol for a few minutes afterwards apply it in the place affected
• Don’t rub just keep it on the stained area
• later on, if the stains seem to be fresh then try and scrub it with a hard brush or even better sandpaper
• In case of chewing gum stuck to your Bearpaw, keep your boots inside the fridge or better take an ice pack and stick it directly onto the gum this will make the gum hard enough for you to just remove or chip it with a brush or hand

Afterwards, rub off with a soft-bristled brush onto the area to remove any extra traces of dirt or gum

7. How to keep your Bearpaw Clean all the Time?

Use a Bearpaw cleaning  kit available in the market

• Protect your Bearpaw with a UGG Protector or Bearpaw cleaning kit to keep them looking new. For best results, clean your boots, with UGG Cleaner & Conditioner before application
• Don’t worry! this product will work exactly the same for Bearpaw as the material used for manufacturing these kinds of the boot are similar
• This kit come with an entire set of Cleaner & Conditioner, Water & Stain Repellent and Freshener along with the direction sample
• Shake well before applying to clean, dry sheepskin or suede in a well-ventilated area. Hold the bottle 6 inches away from the surface. Spray evenly until the surface is wet but not soaked.

Once dry, use suede brush and brush in a single direction to restore the original appearance.

Do’s and Don’ts while cleaning Bearpaw Boots!

• To keep your winter boots keep clean, comfy and in a perfect shape for longer, stuff towels or rolled up scrap paper into them until they stand upright on their own in this way the boots won’t lose their original form
• Store your boots in a cool, dry place away from direct sunlight as it can harm the boots soft layers
• It’s highly discouraged not to use any washer or washing machine to clean your Bearpaw boots cause it may damage the boot surface or even can make changes to the shape or sizes.
• To keep odours out of your winter boots, place a couple of teaspoons of baking soda and a couple of teaspoons of cornstarch into the boots and shake that around. Let that powder mixture sit inside them for a few hours. Dump out the powder mixture once you’re ready to wear your winter boots again.

You had spent money on those trendy, comfortable boots. These tips will help you get your money’s worth and let you enjoy your winter footwear longer.

Conclusion

cleaning your shoes regularly makes the natural fur lose its natural elements. So be always in the upper place to protect your Bearpaw boots  from dirt and dust also Using conditioners and repellent sprays can bring your Bearpaw boots lustrous shine, therefore, before cleaning your comfy and winter perfect Bearpaw boots try not to hastily use any boot cleaning product from any shop or online apps always go for Amazon or verified apps and patiently carry on with the cleaning process  so, that your Bearpaw boots last longer before the winter season gets over

Still, thinking and worrying about How to clean Bearpaw boots? No right! so why wait, just try out these recommended tips for excellent results